Notifications

Clear all

SKRE Gear Hardscrabble Pant Review

Gear Reviews

Last Post by Camron Stover 4 months ago

1 Posts

1 Users

0 Reactions

226 Views

RSS

Camron Stover

(@camron)

Posts: 134

Member Admin

Topic starter

To learn more about the SKRE Gear Hardscrabble Pant, check out our full review at HuntingGearDeals.com

The Hardscrabble Pant held up through a variety of hunting conditions this season and the only thing I’d change is the slight noise generated by the jacket when drawing a bow or walking. It’s not unbearable, but it’s not as quiet as some of my other hunting outer layers. The warmth-to-weight ratio is great, especially when bundled together with the various layering options that SKRE has to offer.

HuntingGearDeals.com has an exclusive coupon code that will save you 15% off full-priced SKRE GEAR at checkout. Just enter the code: HGD-15 at checkout!

SKRE-gear-hardscrabble-pant-review.jpg

Posted : 27/05/2024 5:28 pm

Topic Tags

What is the Bucks, Bulls, & Bears Email Newsletter?

June 4, 2024 No Comments

What is the Bucks, Bulls, & Bears Email Newsletter? Learn what to expect each week in the Bucks, Bulls, and Bears email newsletter.

Stay Positive for Success This Season

April 3, 2024 No Comments

Learning lessons the hard way can be tough and discouraging during hunting season, but the key to success for many is to stay positive!

4 Tips for Whitetail Shed Hunting in 2024

February 5, 2024 1 Comment

By Patrick Long Photo: BryanE on IStock Shed hunting is a fun pastime that we can actually use to scout bucks and spend time with loved ones outdoors. It takes time and can be tough at times but it is super exciting when you find a shed, and even more so when you find a matching set. If it has been said once it has been said a thousand times, but “miles make piles” when shed hunting. To find a lot of sheds, you just have to put in the work. Although there are a few things that you can do to improve your efficiency and make sure you are not missing sheds along the way. Here are four tips that you can use this year to find more sheds. 1 | Shed Hunt during the Right Time Every state’s deer season ends at a different time, but if you want to find a good amount of sheds you should wait a while after the season is over. This also depends on where you plan to shed hunt. If you want to shed hunt public land, you are going to have to go as early and often as you can, because everyone else will too. Just make sure bucks have actually started dropping their antlers before you go. Although if you plan on shed hunting private land, I recommend leaving it be until at least the middle of February. By then most of the bucks around are dropping their antlers. If you are farther north, I recommend waiting until the snow melts in March before going out. I go on at least two trips a year shed hunting on my private land. Your first trip will be the most fruitful. Then wait about another month and try again. This time you will be able to make sure you did not miss any from the former trip, and catch any sheds that bucks may have been holding during your first trip. Other than the time of year, you will want to make sure you shed hunt during the right type of weather as well. Assuming the snow has cleared up, the best day for shed hunting would be a dark and gloomy day. This is probably going to be after a good rain. This kind of weather just makes the color of whitetail antlers stick out from the regular brush. Ideally, that will help you find more sheds, but to be honest most of us shed hunt whenever we find the time. Photo: Aaron J Hill on Pixels.com 2 | Bring the Right Gear One of the best things about shed hunting is that you really do not need a whole lot of gear to do it. Of course, there are a few key pieces of gear that are going to make your job a whole lot easier though. Let’s go over a quick list of shed hunting gear that you may want to take with you. 3 | Look In the Right Places Great, so you are excited to go shed hunting, but where exactly are you supposed to look? Well without being too sarcastic, you should look where the deer are. The first areas you should look at are bedding areas and food sources. These are areas that we commonly hunt, and if you were finding deer during the season, they are likely still there. Personally, I would double down on the feeding areas. After the rut is over, all deer have to focus on feeding and getting ready for winter. While it will technically be winter when you are hunting, deer will have been there weeks before trying to stock up. The trails between food sources and bedding areas are also likely to have a few sheds. Bedding areas can be especially good for finding sheds. Deer are most likely to drop their antlers when they jar themselves, and getting up and down in a bed punches that ticket. Normally I would be wary of going into a bedding area, but deer are going to have all year to get over you spooking them so I say go for it. After you cover those areas, you want to look in some more lucrative places. Again, you want to look in places that deer are going to have to jar themselves. This will hopefully make their antlers drop. Check places like creek bottoms, or fence lines they may jump over. Photo: Trevor Brittingham on Pixabay.com 4 | Bring Someone Along The best part of the outdoors is being outdoors with people you love. Shed hunting is the perfect opportunity to bring someone with you. It is an especially good time to bring someone outdoors that does not frequent the woods. It is good fun to go shed hunting with your hunting buddies, but also try taking a buddy that is not super experienced, or your kids. Shed hunting is great for kids. It introduces them to the outdoors in a very safe way and is exciting enough to get them interested in whitetail and the outdoors. Lastly, you should also bring your dog. Dogs are amazing at finding sheds. So much so that if you ever went with a tried and true shed dog, they would find probably three times as many sheds as you. Even if your dog is not trained as a shed dog, they are still fun to bring along. All and all, shed hunting is a whole lot of fun and is a good tool for scouting. If you bring the right equipment, you can be out there as long as you like and find as many sheds as you and your buddies or kids can carry.

The Do-It-All Gun – .270 Winchester

July 25, 2023 2 Comments

Written by: James House For about 115 years, the .30-06 Springfield has been the favorite caliber for many hunters and target shooters. In more recent years, the .308 Winchester and several other calibers have achieved great popularity. Growing up as I did I read all the gun literature that I could find (or afford) and one of the magazines that I read most was Outdoor Life. The shooting editor for thatmagazine was none other than Jack O’Connor, perhaps the most famous gun writer of all time. Although he wrote about numerous topics and calibers, for many years O’Connor’s writing dealt heavily with the .270 Winchester. Introduced in 1925, the .270 Winchester might be considered to be an “old” cartridge, but with a working pressure as high as 65,000 psi the .270 can be loaded to drive a 130-grain bullet over 3000 ft/sec or a 150-grain bullet about 2900 ft/sec.Such ballistics means that the .270 shoots flat and hits hard. Certainly, the boar that I shot in Tennessee and other animals have responded appropriately. When I was growing up in the middle of nowhere, there was a furniture store in the nearby small town. At one time, the front window of the store displayed a large grizzly that was taken in Alaska by a prominent citizen.The rifle he used, a Winchester Model 70, and a cartridge, a .270 Winchester, were also on display. Thus began my affection for the rifle and cartridge. My .270 Winchester is a Model 770 Winchester, a sort of economy grade Model 70, with which I am celebrating a 50 th Anniversary this year. The Model 770, produced from 1969 to 1971, was a “post ’64 Model 70” so it is a push feed model that has a blind magazine. Thus, it is sort of the Winchester equivalent of the Remington 700 ADL. I have never had a problem withcartridge feeding, firing, or extraction with the rifle, and it gives very good accuracy for a factory rifle. The factory stock on my Winchester 770 has good proportions and pressed checkering. However, it is not an elegant stock by any means. To celebrate my 50-year relationship with the rifle, it has been fitted with a Boyds Platinum stock of Claro XX walnut with fleur de lis checkering and black grip, and fore-end caps. The performance of my Model 770 has always been quite good and now with the Boyds stock that rifle could vie for the title of Safe Queen with many of today’s much more expensive models. Current ammunition listings (note that with the current ammunition situation as it is, I did not say availability) in .270 Winchester caliber include loads from every major and many smaller producers. Virtually all list a 130-grain load having a muzzle velocity of 3060 ft/sec with corresponding energy of approximately 2700 ft-lbs. Bullets styles vary from traditional soft points to a polymer-tipped lead-free version from Swift that is described as having a muzzle velocity of 3151 ft/sec and an energy of 2867 ft-lbs. Swift also lists a load utilizing a 150 Swift A-Frame bullet with a muzzle velocity of 2986 ft/sec and an energy of 2971 ft-lbs. Browning produces a load that utilizes a 140-grain bullet that has a nominal muzzle velocity of 2970 ft/sec giving an energy of 2742 ft lbs. For those who desire the ultimate performance from a .270 Winchester, Hornady offers two loads in the Superformance ® line. One features a 130-grain SST bullet with a muzzle velocity of 3200 ft/sec and an energy of 2955 ft lbs whereas the other utilizes a 140-grain SST bullet with a muzzle velocity of 3090 ft/sec and an energy of 2968 ft-lbs. These loads wring outas much capability as can be expected for a .270 rifle. There are simply too many factory loadings for the .270 Winchester to list them all, but those described show the general parameters Although the recoil of a .270 Winchester is not really severe, some shooters may wish to avoid part of the recoil associated with full power loads. Reduced recoil loads are available fromFederal (with a 140-grain bullet having a velocity of 2200 ft/sec and energy of 1560 ft-lbs) and HSM (130-grain bullet with a velocity of 2318 ft/sec and energy of 1537 ft-lbs). Such loads are certainly adequate for use on animals the size of deer as long as the range is kept within reason. Handloaded ammunition can bring out even more versatility from a .270. For example, bullets are readily available in weights from 90 to 180 grains. In the ‘heavy” category are the 170-grain Berger Elite Hunter, the 175-grain Sierra GameChanger, and the 180-grain Woodleigh. For me, such bullets are not of much interest because I have rifles of larger caliber if I need to prepare to hunt a large animal. In addition, to use on medium game, it has always been the use of my .270 as a varmint rifle that has interested me. For such work, bullets of light weight are appropriate and there are some excellent choices. My first choice has always been the Sierra 90-grain Varminter hollow point because it gives excellent accuracy in my rifle. Much to my dismay, it appears that thebullet has recently been discontinued as has the 100 Hornady 100 grain soft point. However, other good choices are the 90-grain Speer TNT and Gold Dot, the Speer 100-grain hollow point, and the 110-grain Hornady V-Max. When it comes to powders for loading .270 ammunition, I have had very good results with IMR 4064 with lighter bullets and with IMR 4350, Winchester 760, and Alliant Reloder 17 with most bullet weights. In particular, the 90-grain Sierra Varminter gives five-shot groups smaller than one inch with appropriate charges of both IMR4350 and Alliant Power Pro 2000MR. The 100-grain Hornady soft point has shown excellent accuracy when propelled by a suitable charge of Alliant Reloder 17. Having the Winchester 770, I never felt the need for a different .270 on the basis of performance and

Protecting Yourself from Ticks

July 13, 2023 1 Comment

Ticks can pose a threat to outdoor enthusiasts, as they are carriers of tick-borne diseases. Knowing how to protect yourself from ticks is crucial for enjoying the great outdoors safely. This comprehensive guide will provide you with effective preventive measures and tips to minimize the risk of tick bites and the potential health complications they may bring. Conclusion: Protecting yourself from ticks is the best defense against tick-borne diseases. By implementing these preventive measures, including proper clothing, effective use of repellents, regular tick checks, and environmental control, you can reduce the risk of tick bites and enjoy your outdoor activities with greater peace of mind. Remember to seek medical attention promptly if you experience any concerning symptoms after a tick bite or potential exposure to ticks. Stay safe and enjoy the outdoors responsibly!